Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
The owner bought this boat in 1993
General condition and any additional information
1994 Hunter 26 One owner. Well cared for. Fresh water only.
Standard features
Water Ballast with Centerboard - Sits low on the trailer and is easy to launch/recover Draft with keel down - 6ft Draft with keel/rudder up - 1.75ft Water ballast weight – 2000 lbs Empty weight on trailer - 4600 lbs : • Open transom with easy to board swim ladder • Enclosed head • Alcohol stove • Sink • Large seating area with kitchen table that swivels out of the way • Large aft berth • Cooler
Extra gear included
Outboard Motor: 9.9 HP Evinrude long shaft. Electric start. Includes 3, 6 and 7.5 gal gas tanks. Starts and runs great. New water pump.
Trailer: Tandem axel. 4 Wheel disk surge brakes. Bearing Buddies. Spare tire. Requires 2” hitch ball.
Dinghy: 9’ Inflatable. Rigid floor. Includes electric trolling motor and accessories
• Mainsail boom cover • Jib sail bag • Fixed VHF and Handheld VHF radios • Compass and Depth sounder • All cabin and nav light bulbs replaced with LEDs • Manual bilge pump • Battery charger • New deep cycle battery • Life Sling, • Life preservers • 4 dock lines • 3 fenders • 2 anchors
The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.
Classic hull speed formula:
Hull Speed = 1.34 x √LWL
A more accurate formula devised by Dave Gerr in The Propeller Handbook replaces the Speed/Length ratio constant of 1.34 with a calculation based on the Displacement/Length ratio.
Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio.311
Hull Speed = Max Speed/Length ratio x √LWL
A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.
SA/D = SA ÷ (D ÷ 64)2/3
A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.
Ballast / Displacement * 100
A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.
D/L = (D ÷ 2240) ÷ (0.01 x LWL)³
This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.
Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam1.33)
This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.
CSV = Beam ÷ ³√(D / 64)
Water ballast model.(Water stays in place for sailing and pumped out for trailering.)
Replaced by the HUNTER 260 which is very similar.
This listing is presented by SailboatOwners.com. Visit their website for more information or to contact the seller.
Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
©2025 Sea Time Tech, LLC
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.