• 1 / 15
  • 2 / 15
  • 3 / 15
  • 4 / 15
  • 5 / 15
  • 6 / 15
  • 7 / 15
  • 8 / 15
  • 9 / 15
  • 10 / 15
  • 11 / 15
  • 12 / 15
  • 13 / 15
  • 14 / 15
  • 15 / 15

1989 Ta Yang Tayana Vancouver 42

Listed

Seller's Description

This boat comes with: Engine Ynmar 4JHE HP 44 Hours 3,303 12FT. Inflatable With 10 HP Mercury Outboard (2005) 4 Person Life Raft (needs Recertification) BBQ Grill Swim Latter Mase Gen.IS2.5 with only 3 hours Vetus Bow Thruster 75 KGF two Heaters Airtronic MD4 12 Volt and one Electric 120V Sea Frost System 120V Plus Eng. Driven Compressor Freazer has 2 Plates Frige one Plate Seaward 11 GLn Water Heater Maine Sail With Harken Slider Cars Airmar DST 200 Trisensor Garmin GPS Boat Antena Garmin GMI 10 Wind at Nav. Station Garmi Radar 18/18 HD VHF Radio Horizon AIS GX 2150

Equipment: Late Improvements: 2018/2019 all Sheaves Replaced on Mast,Main Boom and Stay Sail Boom Replace all Halyards Including two Spairs Main Sail and Jib Repaird Quarder Birth Saggin Floor to support The Added Weight of new Battery Banks Installed 8 6V Lifeline AGM’s GPL-4CT (House 880 APMH) Start Batt. 1 12V. AGM GPL-3100T Replaced VHF Cable With RG-213 Coax. Converted all Outside Lighting to LED along with installing Blue Sea Lighting Switch Panel Installed two 60 AMP.Xantrex True Charger2 and Installed Remote Panel to Increase Charge Capacity to 120 AMP Repaired Cockpit Leak By Replacing Teak Support Base for Pedestal Installed Instrument POD at Helm Station Intalled full Cockpit Enclosure also Replaced Hard Dodger Strataglass Installed Garmin GPS Map 1242xsv at Helm Installed Garmin GPS Map 742xs at Nav. Station Installed Raymarine Auto Pilot a) E70100 ACU 400 b)E22167 P70R AutoHead c) E70096 EV1 Sensor Core Installed two Burne Stove/Oven ENO Force 10 Model 1423 2021 Replaced Cutless Bearing Replaced Mast Top Wind Sensor With JG Technologies LTD Replaced Engine Kill Swich/Haness Relay Replaced Dripless PSS Repacked Rudder Post Seal Replaced All Anodes Including the one on the Bow Thuster Applyed two Coats of Bottom Paint

Specs

Designer
Robert B. Harris
Builder
Ta Yang Yacht Building Co. Ltd.
Associations
?
# Built
200
Hull
Monohull
Keel
Fin
Rudder
Skeg
Construction
FG

Dimensions

Length Overall
41 6 / 12.7 m
Waterline Length
33 0 / 10.1 m
Beam
12 6 / 3.8 m
Draft
5 1 / 1.6 m
Displacement
29,160 lb / 13,225 kg
Ballast
11,800 lb / 5,352 kg

Rig and Sails

Type
Cutter
Reported Sail Area
833′² / 77.4 m²
Total Sail Area
833′² / 77.4 m²
Mainsail
Sail Area
407′² / 37.8 m²
P
48 8 / 14.8 m
E
16 8 / 5.1 m
Air Draft
?
Foresail
Sail Area
426′² / 39.6 m²
I
54 11 / 16.8 m
J
15 5 / 4.7 m
Forestay Length
57 1 / 17.4 m

Auxilary Power

Make
Yanmar
Model
?
HP
40
Fuel Type
Diesel
Fuel Capacity
120 gal / 454 l
Engine Hours
?

Accomodations

Water Capacity
150 gal / 567 l
Holding Tank Capacity
?
Headroom
?
Cabins
2

Calculations

Hull Speed
7.6 kn
Classic: 7.7 kn

Hull Speed

The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.

Formula

Classic hull speed formula:

Hull Speed = 1.34 x √LWL

A more accurate formula devised by Dave Gerr in The Propeller Handbook replaces the Speed/Length ratio constant of 1.34 with a calculation based on the Displacement/Length ratio.

Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio.311
Hull Speed = Max Speed/Length ratio x √LWL

7.59 knots
Classic formula: 7.7 knots
Sail Area/Displacement
14.1
<16: under powered

Sail Area / Displacement Ratio

A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.

Formula

SA/D = SA ÷ (D ÷ 64)2/3

  • SA: Sail area in square feet, derived by adding the mainsail area to 100% of the foretriangle area (the lateral area above the deck between the mast and the forestay).
  • D: Displacement in pounds.
14.07
<16: under powered
16-20: good performance
>20: high performance
Ballast/Displacement
40.5
>40: stiffer, more powerful

Ballast / Displacement Ratio

A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.

Formula

Ballast / Displacement * 100

40.47
<40: less stiff, less powerful
>40: stiffer, more powerful
Displacement/Length
362.0
>350: ultraheavy

Displacement / Length Ratio

A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.

Formula

D/L = (D ÷ 2240) ÷ (0.01 x LWL)³

  • D: Displacement of the boat in pounds.
  • LWL: Waterline length in feet
362.02
<100: ultralight
100-200: light
200-300: moderate
300-400: heavy
>400: very heavy
Comfort Ratio
43.4
40-50: heavy bluewater boat

Comfort Ratio

This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.

Formula

Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam1.33)

  • D: Displacement of the boat in pounds
  • LWL: Waterline length in feet
  • LOA: Length overall in feet
  • Beam: Width of boat at the widest point in feet
43.43
<20: lightweight racing boat
20-30: coastal cruiser
30-40: moderate bluewater cruising boat
40-50: heavy bluewater boat
>50: extremely heavy bluewater boat
Capsize Screening
1.6
<2.0: better suited for ocean passages

Capsize Screening Formula

This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.

Formula

CSV = Beam ÷ ³√(D / 64)

  • Beam: Width of boat at the widest point in feet
  • D: Displacement of the boat in pounds
1.62
<2: better suited for ocean passages
>2: better suited for coastal cruising

Notes

From BlueWaterBoats.org:

The Tayana Vancouver 42 was the result of a collaboration between the legendary Taiwanese yard Ta Yang and the equally well-known designer Robert Harris. She followed on the heels of the prolific Tayana 37 design by Bob Perry and was one of a series of “Vancouver” designs including 27 and 36 footers. Production started in 1979 and ostensibly continues to this day though it makes much more sense to look at the brokerage market. She has a canoe stern, solid teak joinery, and three different deck plans. This 42-footer is a practical, offshore cruiser on which to cut the dock lines and head for the horizon.

History

Ta Yang made their bones with the Perry designed 37, but Tayana 42 solidified their reputation for quality construction and fine teak interiors. Production started in 1979 and in total about 200 Vancouver 42 hulls have been built. The early Tayanas, from 1979 until 1985 while not overly prone, do have an association will gelcoat blistering. After 1985, the yard switched to an isophthalic gelcoat to resist blistering and, after 1992, laminated the hulls with vinylester resin. Though Ta Yang will make a new one if you want, they have not produced one in some years.

Boat Configuration

The deck configuration comes in three versions – pilothouse aft cockpit, regular aft cockpit, and a center cockpit. Of the 200 about 130 are aft cockpits while the other 70 are center cockpits. The center cockpit is more prized by cruisers for the separate stateroom down below. It is hard to generalize about the interior accommodations because, Ta Yang produced these on a semi-custom basis. Variations include three staterooms layouts, one head with a separate stall shower, two heads with combined sink-shower spaces, a centerline island queen aft, swivel chairs in the saloon, etc. Even the bulkhead positioning could vary. No matter the layout, across the board, the spruce vertical slatting and solid teak trim makes for an exceptionally fine interior.

Construction

Oddly for a serious offshore boat of this vintage, the Tayana 42 features a deck-stepped rig. At least when I think of a bluewater boat I think of a spar stepped on a massive I-beam tied between frames. Though I know there is no difference in safety between properly engineered deck and keel stepped spars. As well Harris’ unique diamond stay at the upper spreaders, supported by an aluminum arc, which some call the cowcatcher, eliminates the need for running backstays. Most have teak decks with all the benifits and pitfalls. The hull is of solid fiberglass. Early decks were cored with plywood while later ones are balsa. The 11,800 pound ballast is a single cast iron insert encapsulated in resin inside the fiberglass keel. These were not only overbuilt but also underpowered with 33hp Yanmars though most have been repowered with 4-cylinder Yanmars generally in the range of 44hp to 75hp.

Under Sail

With her fin keel the Tayana has a more modern underbody than many comparables and sails surprisingly well. She has a double spreader main and cutter rig for 1,000 square feet of canvas. Combined with her heavy displacement of near 30,000 pounds, she is a stout boat that can handle heavy weather, shake off 30 knot winds and make good progress. There is a pronounced sheer for a fair bit of freeboard up forward and a moderate overhang that makes especially the aft cockpit versions pretty dry.

Buyers Notes

The earliest models from 1979 to 1985 are more prone to gelcoat blistering though these days have probably been barrier coated. They may have a plywood cored deck that is less resilient to water saturation. The teak decks are worthwhile to take a close look at. On a few examples fuel and water tankage is of black iron (most have stainless steel water tanks and black iron for fuel), these tanks and more susceptible to rust. Shoddy stainless steel is possible on Taiwanese boats of the late 1970’s and early 1980’s.

Links, References and Further Reading

» Jordan, Richard. Vancouver 36 Review: Smaller Version of 42 Tayana. Waves.
» Kretschmer, John. “Tayana 42.” Used Boat Notebook. Pages 198 – 203.
» Rohde, Bill. “Vancouver 42: A Stately Passagemaker.” Crusing World. March 19, 2009.
» TOG News. The Tayana Owner’s Forum.

This listing is presented by SailboatListings.com. Visit their website for more information or to contact the seller.

View on SailboatListings.com


Embed

Embed

Embed this page on your own website by copying and pasting this code.

Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.

We will occasionally send you relevant updates. You can opt out or contact us any time.

Subscribe

Get occassional updates about new features or featured sailboats.
You can opt out or contact us any time.
Measurements:

Made with ♥ by the founders of Refit Guide
©2022 Sea Time Tech, LLC

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.