Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
The owner bought this boat in 2008
General condition and any additional information
Maintenance: New Cutlass Bearing shaft, coupling and GTX packing 2019. New custom line bags 2019 New raw water impeller 2018 HWH replaced 2015 New damper plate and engine mounts 2011 Fuel tank removed and repaired in 2015, now raised slightly to prevent future corrosion. Oil and heat exchanger zinc, changed every year. Transmission fluid changed every other year. Fuel Tanks drained every year. Batteries kept at float voltage with solar charging system. Water level checked regularly, never deep cycled.
Standard features
DIMENSIONS: LOA: 31’ BEAM: 11’ 6” DISPLACEMENT: 10,700 lbs DRAFT: 4’ 10” BALLAST: 4,400 lbs ENGINE: Universal 3 cylinder 25 hp HOURS: ~900hr
ACCOMMODATIONS AND LAYOUT: Large forward island bed (Vberth) in private cabin Dining area to port side converts to large double berth aft Two dining tables (large for dinner and small for casual times)
RIGGING: Roll Furling Main Roll Furling head sail All Garhauer tackle GROUND TACKEL: (2) Danforth anchor with ~60 of line
GALLEY: Top load and front load Adler Barbour refrigerator/freezer Hillerange 2 burner propane stove with oven Samsung microwave oven
HEAD: Fully enclosed marine head with Jabsco marine toilet, vanity sink and shower
ELECTRONICS AND NAVIGATION EQUIPMENT Raymarine ST60 knot, depth, Ritchie lighted compass Panasonic Combination 12v TV and VCR ELECTRICAL: Full AC/DC electronic panel at chart desk area located starboard aft Battery switch, volt meter Battery charger – Pro Mariner ProSport20 plus 20 amp Sails: 135 UK Ulmer original (fair condition Sunbrella needs re-stitching UK Ulmer Roll Furling Main original (fair condition)
Extra gear included
Other equipment included and notes: Dry boat, no leaks. Custom helm seat that fold to the side for easy boarding. 3rd double birth in salon using a short table post and the larger table with custom cushion. Swivel cleat added for main sheet. (Original clam cleat was difficult to use) Cheek block with jam cleat added for head sail furling (provides for better control when furled). Custom carbon fiber Whisker Poll Additional pull out swim ladder (6) pack life jackets (2) auto inflatable life jackets Electronic safety flair Stainless rail mounted propane grill West Marine hand held VHF radio 3 winch handles All original documentation Mercury 310 Inflatable w/Tohatsu 6hp outboard available.
Improvements to the hull, deck, rigging, engine, or interior
Garhauer davits ELECTRONICS AND NAVIGATION EQUIPMENT: West Marine DCS Fixed Mount VHF600 Radio. Raymarine C90W Wide Screen Multi-function Display w/map GPS Raymarine ST6001 wheel pilot fully integrated with the C90W Raymarine ST60, wind direction/speed Kenwood KMR-330 DC receiver marine stereo (2) Cockpit mounted Polly Planar speakers Kenwood KCA-RC60MR remote control unit PROwatt 150w inverter. Yacht Corrosion Consultants Zinc Saver II (2) 20w Coleman Solar Panels mounted on custom Garhaurer Davits NC25A-12 solar charge controller Cruisair LP-09 Marine Direct Expansion DX Air Conditioning System (2) 4D deep cycle Batteries new 2021 12gal hot water heater Rolly Tasker 135 Genoa new 2012 (good condition) Rolly Tasker roll furling main new 2012 (good condition)
The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.
Classic hull speed formula:
Hull Speed = 1.34 x √LWL
A more accurate formula devised by Dave Gerr in The Propeller Handbook replaces the Speed/Length ratio constant of 1.34 with a calculation based on the Displacement/Length ratio.
Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio.311
Hull Speed = Max Speed/Length ratio x √LWL
A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.
SA/D = SA ÷ (D ÷ 64)2/3
A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.
Ballast / Displacement * 100
A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.
D/L = (D ÷ 2240) ÷ (0.01 x LWL)³
This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.
Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam1.33)
This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.
CSV = Beam ÷ ³√(D / 64)
Wing Keel draft: 4.83’/1.47m
This listing is presented by SailboatOwners.com. Visit their website for more information or to contact the seller.
Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
©2024 Sea Time Tech, LLC
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.