Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.

We will occasionally send you relevant updates. You can opt out or contact us any time.
  • 1 / 2
  • 2 / 2

Seller's Description

New bottom, new transmission, new lifelines, immediately available. Fully equipped for global navigation. Documented vessel

Equipment: Edison helm, autopilot, Raymarine electronics package, main, spinnaker, jib, storm sails. New halyards, A/C, furnace, new std horizon VHF, new thru hull valves


William Crealock
Pacific Seacraft
# Built


Length Overall
34 2 / 10.4 m
Waterline Length
26 2 / 8 m
10 7 / 3.2 m
4 0 / 1.2 m
13,200 lb / 5,987 kg
4,800 lb / 2,177 kg

Rig and Sails

Reported Sail Area
533′² / 49.5 m²
Total Sail Area
533′² / 49.5 m²
Sail Area
241′² / 22.4 m²
34 4 / 10.5 m
14 0 / 4.3 m
Air Draft
44 3 / 13.5 m
Sail Area
292′² / 27.2 m²
40 3 / 12.3 m
14 6 / 4.4 m
Forestay Length
42 10 / 13.1 m

Auxilary Power

Fuel Type
Fuel Capacity
38 gal / 144 l
Engine Hours


Water Capacity
75 gal / 284 l
Holding Tank Capacity
6 3 / 1.9 m


Hull Speed
7.0 kn
Classic: 6.87 kn

Hull Speed

The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.


Classic hull speed formula:

Hull Speed = 1.34 x √LWL

A more accurate formula devised by Dave Gerr in The Propeller Handbook replaces the Speed/Length ratio constant of 1.34 with a calculation based on the Displacement/Length ratio.

Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio.311
Hull Speed = Max Speed/Length ratio x √LWL

7.0 knots
Classic formula: 6.87 knots
Sail Area/Displacement
<16: under powered

Sail Area / Displacement Ratio

A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.


SA/D = SA ÷ (D ÷ 64)2/3

  • SA: Sail area in square feet, derived by adding the mainsail area to 100% of the foretriangle area (the lateral area above the deck between the mast and the forestay).
  • D: Displacement in pounds.
<16: under powered
16-20: good performance
>20: high performance
<40: less stiff, less powerful

Ballast / Displacement Ratio

A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.


Ballast / Displacement * 100

<40: less stiff, less powerful
>40: stiffer, more powerful
275-350: heavy

Displacement / Length Ratio

A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.


D/L = (D ÷ 2240) ÷ (0.01 x LWL)³

  • D: Displacement of the boat in pounds.
  • LWL: Waterline length in feet
<100: ultralight
100-200: light
200-300: moderate
300-400: heavy
>400: very heavy
Comfort Ratio
30-40: moderate bluewater cruising boat

Comfort Ratio

This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.


Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam1.33)

  • D: Displacement of the boat in pounds
  • LWL: Waterline length in feet
  • LOA: Length overall in feet
  • Beam: Width of boat at the widest point in feet
<20: lightweight racing boat
20-30: coastal cruiser
30-40: moderate bluewater cruising boat
40-50: heavy bluewater boat
>50: extremely heavy bluewater boat
Capsize Screening
<2.0: better suited for ocean passages

Capsize Screening Formula

This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.


CSV = Beam ÷ ³√(D / 64)

  • Beam: Width of boat at the widest point in feet
  • D: Displacement of the boat in pounds
<2: better suited for ocean passages
>2: better suited for coastal cruising



The Pacific Seacraft 34 could be considered the encore act to a very successful Pacific Seacraft Crealock 37. Back in 1980, when Pacific Seacraft had freshly acquired the molds of the Crealock 37 from Cruising Consultants and continued its steady production, the company approached designer Bill Crealock to work on a smaller sibling. This new design became known as the Pacific Seacraft 34 (“Voyagemaker”) and it was introduced in 1984. Incidentally, this was the start of a long and very successful association between Pacific Seacraft and Bill Crealock.

It’s not surprising then that the boats share similar graceful lines and appearance. As with the 37, the 34 is focused on safety and comfort. Overall a tough boat with a seakindly nature very well suited for blue-water passage making for couples.

Boat Configuration

The Pacific Seacraft 34 has relatively large overhanging bow, a handsome sheer line, which ends with a traditional canoe stern. Under the waterline is a relatively long cruising fin keel with a very handy draft of 4’11 in standard trim that will get you into places that other boats wont (there’s also an option of a “very” shoal draft 4’1″ option). The rudder is skeg-hung.

The rig is of cutter configuration, all control lines are feed back into the safety of the cockpit. The cockpit is small, which some would say is a traditional blue-water design feature to advert the risk of pooping (flooding from a following sea), hence don’t be surprised if it gets cramped quickly as the people count climbs.

Inside, there is 6’4″ of headroom, a comfortably sized galley, and an interior that is well laid out for liveaboard. There are berths for up to five, two in the V, two in the saloon settees, and a single seagoing quarter berth which doubles as a seat for the nav table.

Sailing Characteristics

Sailing performance is spritely, when taking into account its relatively heavy displacement. The boat is well balanced and is capable of good upwind performance. As with all Pacific Seacraft boats, motion is seakindly, though there is some amount of hobby-horsing to windward due to the overhangs.


The hull is very solid GRP with the outer layer being in vinylester resin to resist osmotic blistering. The deck is cored with end grain balsa. The hull/deck join is above deck. The ballast is lead and externally bolted on. The interior pan runs the full length of the boat. Overall the workmanship is of a very high standard.

Links, References and Further Reading

»Pacific Seacraft Official Site, Pacific Seacraft 34

This listing is presented by Visit their website for more information or to contact the seller.

View on



Embed this page on your own website by copying and pasting this code.

Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.

We will occasionally send you relevant updates. You can opt out or contact us any time.

©2024 Sea Time Tech, LLC

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.