Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
Cadence has been maintained in above-average condition and has very low engine hours. She is hull #1041 of this proven Catalina model. A December 2021 haul out survey concluded that the Overall Vessel Condition is Very Good. The survey report is available to review. Wing keel, double spreader rig. Cadence is readily sailed short-handed with an in-mast furling mainsail and 150% roller furling genoa. Control lines are lead aft to rope clutches on the cabin top.
Equipment: Yanmar 3YM30 27 hp diesel with 255 hours. The engine exhaust mixing elbow was replaced in 2022. Cadence is well equipped for coastal cruising with plenty of storage. Walk through transom with swim platform. Air conditioner/reverse cycle heat, refrigerator, LPG stove, hot and cold pressure water, shower in head, cockpit shower. Electric windlass and anchor locker. Rocna anchor on bow roller, danforth secondary anchor. Dodger, bimini, and connector with sun covers on all windows. Full length helm cover. Four winch covers. Boom tent. New equipment for 2021 includes: Raymarine speed-depth and wind instruments, chart plotter, and EV-100 autopilot. New engine alternator, battery charger, AGM house and starting batteries. Bottom paint December 2021
The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.
Classic hull speed formula:
Hull Speed = 1.34 x √LWL
A more accurate formula devised by Dave Gerr in The Propeller Handbook replaces the Speed/Length ratio constant of 1.34 with a calculation based on the Displacement/Length ratio.
Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio.311
Hull Speed = Max Speed/Length ratio x √LWL
A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.
SA/D = SA ÷ (D ÷ 64)2/3
A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.
Ballast / Displacement * 100
A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.
D/L = (D ÷ 2240) ÷ (0.01 x LWL)³
This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.
Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam1.33)
This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.
CSV = Beam ÷ ³√(D / 64)
Draft for winged keel vers: 1.3m/4.25’
Updated MARK II version introduced in 1999.
This listing is presented by SailboatListings.com. Visit their website for more information or to contact the seller.
Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.
©2024 Sea Time Tech, LLC
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.